Honeywell DIN Rail Temperature Transmitter

Product Description

Our firm is offering top-quality Honeywell DIN Rail Temperature Transmitter which is made by using best quality required materials with the help of sophisticated technology under the supervision of our experts. It is a gadget that interfaces with a temperature sensor to transmit the sign somewhere else for observing and control purposes. Offered Honeywell DIN Rail Temperature Transmitter used to changes over low level info signals from field sensors to a relative current sign that is perfect for driving board meters, recorders, controllers, PCs and other instrumentation.

Product Details :

Reliable measurement :

• Built in 1500VAC Galvanic Isolation
• Superior noise performance
• Sensor error detection in accordance with Namur 89

Lower Cost of Ownership :

• Universal input
• Dual channel option saves panel space
• Easy to configure, install and commission
• Can double up as position and level transmitters for valves and ohmic level sensors.

All the STT650 DIN Rail models with universal input are tested for the following parameters:

• Conducted Noise - 10Vrms in the range of 15Hz to 100MHz
• Radiated Noise - 10V/m in the range of 80 to 1000MHz
• Surge test - 1KV Differential mode ; 2 KV Common mode
• Burst Noise - 2.5KV

STT650 RTD Input type :

• Analog 4-20 mA output
• RTD or Ohm input
• Single or dual channel option
• NAMUR NE43 sensor error response
• Programmable using the STT17C PC Configuration tool
• STT650 Universal Input type - Analogue Output only
• Analog 4-20 mA output
• RTD, T/C, Ohm or mV input
• NAMUR NE43 sensor error response
• Programmable using STT17C PC configuration tool
• Galvanic isolation

STT650 Universal Input type - HART protocol :

• HARTTM/4-20 mA output
• RTD, T/C, Ohm or mV input
• Single or dual channel option
• Supports Differential or Averaging measurement
• NAMUR NE43 sensor error response
• Programmable using MCT404 or STT17C PC configuration tool
• Galvanic isolation
• STT650 Universal Input type - FF/PA Protocol
• Foundation TM Fieldbus protocol
• PROFIBUS PA protocol
• RTD, T/C, Ohm or mV input +mA +/- 100mA
• Single or dual (difference, average or redundant) sensor input
• Function blocks: 2 analogue, 1 PID
• FISCO certified
• Basic or LAS capability
• Galvanic isolation

Configuration Tools :

• The STT17C configures the STT650 programmable and HART units.
• The intuitive graphical user interface of the STT17C virtually eliminates the need for operator training after installation on a PC
• The STT17C includes all software and transmitter interface hardware necessary to configure the STT650 programmable and HART models in non-hazardous work environments
• Warning: The STT17C is not approved for use in Hazardous work environments